GIFSQ ID: CAL-0546
GIFSQ Tools : Dairy : Version v1 : Technical review date: 2026-11-15
Kilograms of whole milk powder (and water) to add to milk to reach a target total solids and fat content, for standardisation or recombination.
Educational calculator: this is a calculation aid for learning and planning. It is not a validated food safety process and must not be presented as one. Confirm any value against your accredited method and your own process validation before using it in production.
Inputs
Formula
Overall: milk + powder + water = final mass. Total solids: milk x TS% + powder x powder TS% = final x target TS%. Fat: milk x fat% + powder x powder fat% = final x target fat%. Solve the two equations for powder kg and water kg. Powder total solids % and fat % are entered from the powder specification.
Variable definitions and units
Milk, powder, water, final mass: kg. Total solids and fat: % w/w. Powder composition must come from its specification, not assumed by the tool.
Assumptions
Powder dissolves fully. No losses. Powder composition is as entered from its specification.
Input validation
All kg 0 or greater. Percentages 0 to 100%. Target total solids % and fat % achievable from the entered powder; the tool rejects impossible targets. Powder total solids % greater than target total solids %.
Worked example
No worked powder-addition calculation with numbers is given in the books, so no book worked example is shown. Bylund describes recombination (condensed milk from recombined milk with skim milk powder, anhydrous milk fat and water, Ch. 16; recombined milk products, Ch. 18) and gives a reconstitution ratio: one part spray-dried milk powder mixed with about ten parts water at 30 to 50 C (Ch. 18). Bylund also notes MSNF is increased by addition of milk powder (Ch. 11) and skim milk or protein powder addition of usually 1 to 3% (yoghurt, Ch. 11). The test below is a closure check: the solver result is fed back into the two balance equations and must return the target total solids and fat.
Expected output
Powder kg, water kg, final mass kg, and final total solids % and fat % as check values (they must equal the targets).
Calculation limitations
No book worked example. Powder composition varies by supplier and must be entered. Reconstituted milk is not identical to fresh milk; the tool must not present a recombined product as fresh milk.
Source
Bylund, Dairy Processing Handbook, Tetra Pak, 2003, Ch. 6.2 (mass balance method), Ch. 11, Ch. 16, Ch. 18 (reconstitution ratio about 1 part powder to 10 parts water). Typical whole milk powder total solids about 96 to 97% is not in the books and is not assumed; enter it from the specification.