Butter Manufacture β Part 1
GIFSQ ID: ART-0870
What this quiz covers
Butter looks simple, a block of fat on the breakfast table, but making it well is a chain of small decisions: how the cream is ripened, how cold it is churned, how the grains are worked and salted, and how the finished butter is stored. This quiz covers the first half of that chain: twenty questions on butter manufacture, from the compound behind its flavour to the temperatures, salt and overrun that decide its quality. Each defect in the set has a cause a maker can trace and fix.
You will start with flavour and composition: diacetyl, the 16 percent moisture ceiling, and annatto, the natural colour that evens up pale winter butter. Then come the process numbers: cream ageing at 5 to 10 degrees C, starter at 0.5 to 2.0 percent, churning at 9 to 11 degrees C, and overrun capped near 25 percent. The set closes with the science underneath: why small globules churn slowly, why butter is a water-in-oil emulsion, and which off-flavours lipase and proteolytic bacteria cause.
Why butter rewards careful numbers
Butter has little room for error because its composition is fixed by law and its texture is set by temperature. A few degrees too warm in the churn gives weak, greasy butter; a little too much water worked in breaches the moisture ceiling. Learning the standard figures, and the reason behind each, is what lets a maker repeat good butter batch after batch.
How to use this quiz
Take it cold first, then read the explanations below the player. Each answer explains why the correct choice is right in plain words, so a wrong answer becomes a fact you keep. Use it as a revision round before an exam or a job interview, and come back to the questions you missed.
Choose how you want to play
Answer explanations
Worked through the quiz? Here is why each correct answer is correct: the concept behind it, in plain terms.
- Good butter smells unmistakably buttery, and one compound is responsible. The characteristic flavour of butter comes mainly from which compound?
Correct answer: Diacetyl: Diacetyl, made by citrate-fermenting lactic cultures while cream ripens, is the compound behind butter’s buttery note. - Butter is mostly fat, but water is worked in during manufacture. Moisture in butter is generally about what percentage?
Correct answer: 16%: Butter runs about 16 percent moisture, the legal ceiling in most countries, the rest being fat, salt and curd. - Winter butter looks pale, so makers add a natural golden colour. The yellow colour of butter is commonly intensified with which natural colour?
Correct answer: Annatto: Annatto, the natural golden colour from Bixa orellana seeds, evens up pale winter butter. - A butter-maker reports how much extra weight was gained over the fat churned. Overrun in butter making is expressed in what units?
Correct answer: As a percentage: Overrun is butter made minus fat churned, divided by fat churned, times 100, so it is expressed as a percentage, typically 20 to 25 percent. - Cream rests in a cool room before churning so the fat firms up. Cream for butter making is aged (ripened) at about what temperature?
Correct answer: 5 to 10Β°C: Cream is aged cold, near 5 to 10 degrees C, so milk fat crystallises properly for clean churning and firm body. - A starter culture ripens cream before it becomes butter. What level of starter culture is used to ripen cream for butter?
Correct answer: 0.5 to 2.0%: Starter goes into cream at 0.5 to 2.0 percent of cream weight, then incubates near 21 degrees C for 15 to 16 hours to build acidity and diacetyl. - Homogenized cream churns sluggishly compared with ordinary cream. Smaller fat globules make the churning period do what?
Correct answer: Lengthen it: Small fat globules churn slowly because their large total surface and sturdy membranes resist the phase inversion that gathers butter grains. - A batch of unusually thick cream takes forever in the churn. Greater viscosity of the cream makes the churning period do what?
Correct answer: Lengthen it: Thick, viscous cream takes longer in the churn because the globules collide and aggregate less freely. - Butter grain depends on churning at exactly the right coolness. What is the optimum temperature range for churning cream into butter?
Correct answer: 9 to 11Β°C: Cream churns best near 9 to 11 degrees C, cool enough for firm grains, warm enough for globules to coalesce; warmer gives weak greasy butter, colder gives brittle sticky butter. - A churn run too warm yields butter that slumps and leaks. Churning at too high a temperature gives butter of what body?
Correct answer: Weak: Churning too warm leaves too much fat liquid, so the butter comes out with a weak, spongy body. - High-fat cream butters faster than thin cream. How does a higher fat percentage change the churning period?
Correct answer: Shorten it: Richer cream butters faster because more globules per unit volume aggregate into grains sooner. - Efficient churning leaves little fat in the leftover buttermilk. Larger fat globules result in what level of fat loss into the buttermilk?
Correct answer: Lower: Big globules rupture and coalesce readily, so less fat escapes into the buttermilk. - Butter-makers have three traditional ways to salt their product. Which methods are used for salting butter?
Correct answer: Dry, wet, and brine salting: All three traditional methods are used: dry salt worked into grains, salt added with water, and brining the grains. - Butter salt must taste clean, not bitter. Which salt is used for salting butter?
Correct answer: Sodium chloride: Butter salt is essentially pure sodium chloride, ground fine so it dissolves completely; calcium, magnesium or potassium chlorides would taste bitter or metallic. - Butter is stored for months before sale. Around what temperature does commercial cold storage of butter run?
Correct answer: β23 to β29Β°C: Butter for long commercial storage is held at minus 23 to minus 29 degrees C, which arrests microbial and oxidative spoilage for months. - Regulations limit how much extra weight a butter-maker can work in. The overrun in butter making is generally limited to about what?
Correct answer: Not more than 25%: Normal overrun runs 20 to 25 percent; past about 25 percent the butter turns foamy and breaches the 16 percent moisture ceiling. - Butter holds water droplets trapped inside solid fat. Butter is which type of emulsion?
Correct answer: Water in oil: Butter is a water-in-oil emulsion, microscopic water droplets dispersed through a continuous fat phase, the phase inversion churning achieves. - Butter must be conditioned before the wrapping machine shapes it. Tempering of butter before packing is done at about what temperature?
Correct answer: 16Β°C: Before packing, butter is tempered to about 16 degrees C, firm enough to hold shape, pliable enough for wrapping machines without oiling off or cracking. - Unwanted enzyme action during butter preparation spoils the flavour. Lipase activity produces which off-flavour?
Correct answer: Bitter: Lipase hydrolyses butterfat to free fatty acids, and the defect table lists bitterness from lipase activity during cream separation. - Bacteria that digest protein can taint butter with an odd flavour. Proteolytic bacterial activity leads to which flavour defect?
Correct answer: Cheesy: Proteolytic bacteria split milk proteins into nitrogenous compounds that smell distinctly cheesy; keeping cream at 5 degrees C or below prevents it.